|
Sign In to gain access to subscriptions and/or personal tools.
|
Factors Influencing the Creep of Dental Amalgam
D.B. Mahler
Oregon Health Sciences University, 611 SW Campus Drive, Portland, Oregon 97201
J.D. Adey
Oregon Health Sciences University, 611 SW Campus Drive, Portland, Oregon 97201
The purpose of this study was to investigate the influence of relevant microstructural and compositional factors on the creep of 12 representative dental amalgams by means of stepwise multiple linear regression. The independent variables accepted by the regression were volume percent of the '(Cu6Sn5) phase, grain size of the 1 (Ag2Hg3) phase, volume percent of the y (Ag3Sn) plus E (Cu3Sn) phases, number of very small ' crystals (< 1.5µm) per mm, and weight percent of Hg. The results of this regression showed an adjusted R2 of 0.949, significant at p = 0.002.
REFERENCES
- Bendel, R.B. and Afifi, A.A. (1977): Comparison of Stopping Rules in Forward "Stepwise" Regression, J Am Statist Assoc 72:46-53.[CrossRef]
- Cohen, J. and Cohen, P. (1983): Applied Multiple Regression/Correlation Analysis for the Behavioral Sciences, 2nd ed., Hillsdale, NJ: Lawrence Erlbaum Associates, Inc., Publishers, pp. 106, 124, 125.
- Colby, J.W. (1968): Quantitative Microprobe Analysis of Thin Insulating Films, X-ray Anal 11:287-305.
- Crawford, W.H. and Larson, J.H. (1955): Residual Mercury Determination Process, J Dent Res 34:313-317.[Free Full Text]
- Dehoff, R.T. and Rhines, F.N. (1968): Quantitative Microscopy, New York: McGraw-Hill Book Co., pp. 67-68.
- Espevik, S. (1977): Creep of Dental Amalgam and Its Phases, Scand J Dent Res 85:492-495.[Medline]
[Order article via Infotrieve]
- Hilliard, J.E. and Cahn, J.W. (1961): An Evaluation of Procedures in Quantitative Metallography for Volume-Fraction Analysis, Trans Metals Sco AIME 221:344-352.
- Johnson, L.B. and Paffenbarger, G.C. (1980): The Role of Zinc in Dental Amalgams, J Dent Res 59:1412-1419.[Abstract/Free Full Text]
- Mahler, D.B. (1979): Behavior of Three High-Cu Amalgams, J Biomed Mater Res 13:693-699.[CrossRef][Medline]
[Order article via Infotrieve]
- Mahler, D.B. and Adey, J.D. (1979): The Influence of Final Mercury Content on the Characteristics of a High-Copper Amalgam, J Biomed Mater Res 13:467-476.[CrossRef][Medline]
[Order article via Infotrieve]
- Mahler, D.B.; Adey, J.D.; and Marantz, R.L. (1977): Creep Versus Microstructure of
2-Containing Amalgams, J Dent Res 56:1493-1499.[Abstract/Free Full Text] - Mahler, D.B.; Adey, J.D.; and Marek, M. (1982): Creep and Corrosion of Amalgam, J Dent Res 61:33-35.[Abstract/Free Full Text]
- Mahler, D.B.; Terkla, L.G.; Van Eysden, J.; and Reisbick, M.H. (1970): Marginal Fracture vs. Mechanical Properties of Amalgam, JDent Res 49:1452-1557.
- Mahler, D.B. and Van Eysden, J. (1969): Dynamic Creep of Dental Amalgam, J Dent Res 48:501-508.[Abstract/Free Full Text]
- Okabe, T.; Mitchell, R.; Butts, M.B.; and Fairhurst, C.W. (1978): A Study of High Copper Amalgams III. SEM Observations of Amalgamation of High Copper Powders, J Dent Res 57:975-982.[Free Full Text]
- Osborne, J.W. and Gale, E.N. (1990): Microstructure and in vivo/invitro Performance of Amalgams, JDent Res 69:286, Abst. No. 1419.
- Wing, G. (1965): The Microstructure of Dental Amalgam, Aust Dent J 10:113-120.[Medline]
[Order article via Infotrieve]
Journal of Dental Research, Vol. 70, No. 11,
1394-1400 (1991)
DOI: 10.1177/00220345910700110101

CiteULike Complore Connotea Del.icio.us Digg Reddit Technorati Twitter What's this?
This article has been cited by other articles:

|
 |

|
 |
 
K. Asaoka
Effects of Creep Value and Occlusal Force on Marginal Adaptation of Amalgam Filling
Journal of Dental Research,
September 1, 1994;
73(9):
1539 - 1545.
[Abstract]
[PDF]
|
 |
|
|
|